Yamaha QL5 Ql Editor Owner's Manual - Page 77

1 Link buttons Use these buttons to select the link group A-Z, a-n to which you want each input channel to be assigned. If you don't want an input channel to be linked, select NONE. You can assign up to forty groups for INPUT CH 1-64 (QL1: 1-32 and ST IN CH 1-8.) 2 CLEAR ALL Clears the link settings for all channels. 3 LINK GROUP button If you select a link group using one of the corresponding Link buttons (1), the LINK GROUP button will automati- cally select the same link group. 4 LINK PARAMETER This section enables you to select the parameters to interlock. HA HPF DIGITAL GAIN EQ DYNAMICS1 DYNAMICS2 INSERT DIRECT OUT MIX SEND MIX ON MATRIX SEND MATRIX ON FADER DCA CH ON MUTE TO ST DELAY Head amp gain and phantom power settings HPF settings DIGITAL GAIN settings Equalizer settings Dynamics 1 settings Dynamics 2 settings INSERT settings DIRECT OUT settings Send amount from input channel to MIX bus MIX SEND on/off Send amount from input channel to MATRIX bus MATRIX SEND on/off Fader level value DCA settings Input channel module output on/off Mute settings TO ST settings Delay settings NOTE The HA, FADER, DIGITAL GAIN, and DELAY parameters will maintain level differences between linked channels. 5 SEND PARAMETER Specify the link status for each MIX/MATRIX SEND bus. 77 QL Editor Owner's Manual