Yamaha QL5 Ql Editor Owner's Manual - Page 8

Synchronizing QL Editor When QL Editor starts up, the parameter settings on the console and the parameter settings in QL Editor may be different. Therefore, you must first match the parameter settings on the console with those in QL Editor. This operation is called "synchronization." Follow the steps below to synchronize QL Editor. 1 Select [Synchronization], then [Re-synchronize]. The following window opens. NOTE If QL Editor is in the offline status the [Re-synchronize] function is not available. 2 Select whether you want to transfer your settings to QL Editor, or vice versa. Console -> PC: Transfers the current parameter settings of your console to the QL Editor. PC -> Console: Transfers the current parameter settings in QL Editor to your console. At this time, the All Libraries option determines whether or not Library data is synchronized. If you select the [Dante Setup and I/O Device] check box, Dante settings will also be synchronized. Clear this check box if you want to preserve the Dante settings of the QL console when using PC -> Console. NOTE The Dante settings of the QL console will be copied to QL Editor if you clear this check box and select PC -> Console, or if you select Console -> PC. 3 Click [OK]. Do not operate the console while synchronization is in progress. Offline Edit Function If you do not want to synchronize your console with QL Editor, select [Offline Edit] from the [Synchronization] menu. To apply your off-line edits to your console, select [Re-Synchronize] from the [Synchronization] with the PC -> Console option to synchronize the console with QL Editor. The Offline Edit function is also activated when you click the [ONLINE]/[OFFLINE] button in the Master window. NOTE Some effect parameters in the console change their displayed values depending on the sampling frequency. If you switch QL Editor from OFFLINE to ONLINE, displayed parameter values may change because QL Editor loads the sampling frequency from the console and updates the display. Other Functions ❏ Resetting to the default value (Ctrl( )+click) Move the cursor to a control or a parameter value, then hold down the (< >) key and click the mouse button to reset the value to the default (e.g., to reset a pan setting to Center). However, the channel faders and the send knobs and bar graphs can be set to -∞ regardless of the default value. ❏ Ctrl( )+Shift+Click Move the mouse cursor to a channel fader or to a send knob or bar graph, and click while holding down the (< >) key and key to set the nominal value regardless of the default value. 8 QL Editor Owner's Manual