Yamaha UW500 UW500 Owners Manual - Page 14

Parts and Functions s Rear Panel 90A B C D E FG L R I OUTPUT jacks These jacks are used to connect a playback device, such as powered speakers, or a recording device, such as a tape recorder. Use RCA pin-plug cables for L and R connection. J AUX IN jacks These jacks are used to connect an audio device, such as a CD player. The input signal is routed to the OUTPUT jacks and PHONES jack, bypassing the computer. (The signal is not routed to the DIGITAL OUT jack.) Use RCA pin-plug cables for L and R connection. NOTE You cannot record an audio signal input from these jacks to the computer. To record audio to the computer, use the INPUT 3 jacks. K INPUT 3 jacks These jacks are used to connect an audio device, such as a CD player. You can record audio signals input here to the computer. Use RCA pinplug cables for L and R connection. NOTE Even if the INPUT SELECT switch is set to "MONO," these jacks receive stereo 14 signals. L DC IN jack Connect the PA-3B power adaptor here. Before connecting the power adaptor, make sure that the OUTPUT knob on the unit is set to standby (off). Connect the power adaptor to the DC IN jack, then plug the adaptor into the AC outlet. M INPUT SELECT switch This switch enables you to select the input jacks (INPUT 1-3 or DIGITAL IN) and select the type of input signal. To input stereo signals from an electronic musical instrument or audio device to INPUT 1-2 jacks (left signal to INPUT 1 and right signal to INPUT 2), set this switch to "STEREO." To input monaural signals from a microphone or electric guitar to INPUT 1 and 2 jacks, set the switch to "MONO." To input digital signals to the DIGITAL IN jack, set the switch to "DIGITAL." NOTE You cannot use DIGITAL IN and INPUT 1-3 at the same time.