ZyXEL NBG-416N User Guide - Page 39
Setting your NBG-416N to Router Mode - - wireless router
View all ZyXEL NBG-416N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Chapter 4 Modes 4.2 Setting your NBG-416N to Router Mode The NBG-416N is set to wireless router mode by default. If it was changed and now you want to set it back, do the following procedure. 1 Connect your computer to the LAN port of the NBG-416N. 2 The default LAN IP address of the NBG-416N is 192.168.1.1 in router mode (192.168.1.2 by default in non-router mode). In router mode, the NBG-416N can assign your computer an IP address, so you must set your computer to get an IP address automatically (computer factory default) or give it a fixed IP address in the range between 192.168.1.3 and 192.168.1.254. 3 After you've set your computer's IP address, open a web browser such as Internet Explorer and type the IP address of the NBG-416N as the web address in your web browser. 4 Log into the Web Configurator. See the Chapter 2 on page 19 for instructions on how to do this. 5 Go to Maintenance > Sys OP Mode > General and select Router. Figure 24 Maintenance > Sys OP Mode > Router 6 A pop-up window appears providing information on this mode. Click OK in the pop-up message window. Click Apply. Note: Wait while the NBG-416N restarts, then log in to the Web Configurator again. The NBG-416N IP adress is now 192.168.1.1. NBG-416N User's Guide 39