1993 Chevrolet Camaro Owner's Manual - Page 255

r 1 ... I 3. Pull the headlight out of the assembly. 6. Place the new headlight in the 9. Check the headlight aim indicators. Remove the wiring connector from the headlight assembly. The socket must The horizontal indicator (A) should be be pointing in the same direction the headlight socket by lifting the plastic on 0 (zero). If the vehicle is level, the socket on the burned out bulb was. locking tabs on the connector and vertical indicator (B) should also be pulling it from the socket. on 0 (zero). If the vehicle isn't level, 7. Insert the tabs on the aiming ring into check the vertical aim on a level 4. Check the new headlight again. The the slots in the headlight assembly. surface as soon as you can. Ifeither number on the light must match the 8. Hold the aiming ring closed, insert the indicator doesn't read "0," adjust the number on the headlight being screws at the endof the ring. Tighten headlight aim. See "Adjusting replaced. The letter, "U" or "L," the screws until the aiming ring Headlight Aim" in the Index. must also match. touches the plastic nuts on both the If your vehicle is damaged in an accident top and bottom. Do not overtighten. 5. Plug the wiring connector into the and the headlight aim seems to be headlight socket. Snap the locking Do not damage the vertical aiming affected, see your Chevrolet dealer. tabs onto the socket. bubble. Headlights on damaged vehicles may require recalibration of the horizontal aim by your Chevrolet dealer. 251