1995 Chevrolet Camaro Owner's Manual - Page 152

Setting Your Security Code The instructions below tell you how to enter a security code into the system. If your vehicle loses battery power for any reason, you must enter the security code again before the system will turn on. 1. Write down anysix-digit number and keep it in a 8. Press the lower knob and"OOO" will appear. Now you are ready to enter the last three digitsof your code. 9. Press SCAN and hold until the fourth digit of your code appears. Release the button. 10. Press SEEK 4 or b and hold untilthe fifth and sixth digits of your code appears. Release the button. 11. Press the lower knob. rEP will appear for five seconds, and then "000" will appear. 12. For verification, repeat steps 6 through 11. If "SEC" appears, your audio system is secured. If "---" shows on the display, your system is not secured. must You restart the entire procedure again fromstep 4. safe place. 2. Turn the ignition switch to the ACC or RUN position. 3. Turn the audio system off. 4. Press and hold pushbuttons 1 and 4 together until '&- -" shows on the display. You are now ready to enter your security code. Don't wait more than 15 seconds between steps. 5 . Press SET and "000" will appear on the display. 6. Press SCAN and hold it until first digit of the the Shutting Off the Theft-Deterrent Feature If your audio system is secured (SEC shows on display) and you wish to disable it, enter your security code as follows, pausing no more than 15 seconds between steps: 1. Turn the ignition on. Make sure the audio system is off. The time will show on the display. code appears. 7. Press SEEK 4 or SEEK b and hold until the second and thirddigits of your code appears. Release the button. 2. Press pushbuttons 1 and 4 together until SEC shows on the display. 3-14