1995 Chevrolet Camaro Owner's Manual - Page 275

4. Check the new headlamp again. The number on the lamp must match the number of headlamp being the replaced. The letter U or L must also match. 5. Plug the wiring connector into the headlamp socket. Snap the locking tabs onto the socket. 6. Place the new headlamp in the headlamp assembly. The socket must be pointing in the same direction the socket on the burned out bulb was. 7. Insert the tabs on the aiming ring into the tabs in the headlamp assembly. 8. Hold the aiming ring closed, insert the screws at the end of the ring. Tighten the screws until the aiming ring touches the plastic nuts on both the top and bottom. Do not overtighten. Do not damage the vertical aiming bubble. 3. Pull the headlamp out of the assembly. Remove the wiring connector from the headlamp socket by lifting the plastic locking tabs on the connector and pulling it from the socket. 6-43