2014 Ford Expedition Owner Manual Printing 1 - Page 158

Universal Garage Door Opener (If Equipped) 157 Fixed Code Programming Note: It may be helpful to have another person assist you in programming the transmitter. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 1. Switch the ignition on. 2. Open the battery cover and note all the switch settings from left to right. When the switch is in the up, on, or + position, mark down "left button". When the switch is in the middle, neutral, or 0 position, mark down "middle button". When the switch is in the down, off, or - position, mark down "right button". 3. Press all three function buttons simultaneously for a few seconds and then release. The LED lamps will flash slowly. Note: The following step must be completed within 2.5 minutes. 4. Enter the corresponding DIP switch settings from left to right into the system by pressing and releasing the buttons corresponding to the settings you noted. 5. Simultaneously press and release all three function buttons. The LED lamps will illuminate. 6. Press and hold the function button you would like to use to control the garage door. Note: You may need to hold the button from 5-55 seconds before observing movement of the garage door. 7. When the garage door moves, release the button within one second. When the button is released, the LED lamp will flash slowly. 2014 Expedition (exd) Owners Guide gf, 1st Printing, June 2013 USA (fus)