2014 Ford Expedition Owner Manual Printing 1 - Page 78

Locks 77 • Pressing 3•4 in Step 4 will program the code to driver memory setting 2. Note: Pressing 5•6, 7•8, or 9•0 keypad numbers in Step 4 will not program the code to recall a driver memory setting. Note: The factory-set code cannot be associated with a memory setting. Erasing a Personal Code 1. Enter the factory-set 5-digit code. 2. Press and release the 1•2 on the keypad within five seconds. The doors will lock and then unlock to confirm that the system is in programming mode. 3. Press and hold the 1•2 for two seconds. You must do this within five seconds of completing Step 2. All personal codes are now erased and only the factory-set 5-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control • the ignition is turned on. Unlocking and Locking the Doors and Liftgate To unlock the driver door: Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. To unlock all doors and liftgate: Enter the factory-set 5-digit code or your personal code, then press 3•4 within five seconds. To lock all doors and liftgate: Press and hold 7 •8 and 9•0 at the same time with the driver door closed. You do not need to enter the keypad code first. To open the liftgate glass: Enter the factory-set 5-digit code or your personal code, then press 5•6. 2014 Expedition (exd) Owners Guide gf, 1st Printing, June 2013 USA (fus)