2014 Ford Expedition Owner Manual Printing 1 - Page 162

Universal Garage Door Opener (If Equipped) 161 Erasing the Function Button Codes Note: You cannot erase individual buttons. 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the indicator lights above the buttons flash rapidly. 2. When the indicator lights flash, release the buttons. The codes for all buttons are erased. Reprogramming a single button To program a device to a previously trained button, follow these steps: 1. Press and hold the desired button. Do NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink® at www.homelink.com or 1-800-355-3515. Programming HomeLink to a Genie Intellicode 2 garage door opener Note: The Genie Intellicode 2 transmitter must already be programmed to operate with the garage door opener. Programing the transmitters To program HomeLink to the transmitter you must first put the transmitter into programming mode. To do this: A. Red LED B. Green LED A B 1. Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The LED light will change from green to green and red. 2014 Expedition (exd) Owners Guide gf, 1st Printing, June 2013 USA (fus)