2014 Ford Expedition Owner Manual Printing 1 - Page 81

80 Security 6. Turn the ignition off and remove the second previously programmed coded key from the ignition. 7. After three seconds but within 20 seconds of turning the ignition off and removing the previously programmed coded key, insert the new unprogrammed key into the ignition. 8. Turn the ignition from off to on. Keep the ignition on for at least six seconds. 9. Remove the newly programmed coded key from the ignition. The key will start the vehicle's engine and will operate the remote entry system (if the new key is an integrated keyhead transmitter) if it has been successfully programmed. The theft indicator light will illuminate for three seconds and then go out to indicate successful programming. If the key was not successfully programmed, the theft indicator light may flash on and off. Wait 20 seconds and repeat Steps 1 through 8. Take your vehicle to your authorized dealer to have the new key programmed if you are still unsuccessful. Wait 20 seconds and then repeat this procedure from Step 1 to program an additional key. ANTI-THEFT ALARM The system will warn you of unauthorized entry to your vehicle. The turn signal lamps will flash and the horn will sound when: • any door or the hood is opened without using the key or the remote control • the ignition is turned on with an invalid key. Take all keys and remote controls to your authorized dealer if there is any potential alarm problem with your vehicle. Arming the Alarm The system is ready to arm whenever the ignition is off. Lock the vehicle to arm the alarm. The turn signal lamps will flash once after locking the vehicle to indicate the alarm is in the pre-armed mode and will become fully armed in 20 seconds. 2014 Expedition (exd) Owners Guide gf, 1st Printing, June 2013 USA (fus)