2014 Ford Expedition Owner Manual Printing 1 - Page 86

Wipers and Washers 85 WINDSHIELD WIPERS Note: Fully defrost the windshield before turning on the windshield wipers. Note: Make sure the windshield wipers are turned off before entering a car wash. Note: Clean the windshield and wiper blades if they begin to leave streaks or smears. If that does not resolve the issue, install new wiper blades. Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to bun out. Always use the windshield washers before wiping a dry windshield. Rotate the end of the control: • away from you to increase the wiper speed 2 1 • toward you to decrease the wiper speed. Speed Dependent Wipers When your vehicle speed increases, the interval between wipes will decrease when intermittent wipe is selected. RAIN-SENSING WIPERS (IF EQUIPPED) Note: Wet road conditions may result in inconsistent or unexpected wiping or smearing. Lower the sensitivity, switch to normal or high-speed wiping or turn the wipers off to reduce smearing. Note: Turn off the wipers before entering a car wash. Use the rotary control to adjust the sensitivity to one of the interval moisture settings. The wipers will 2 not cycle until moisture is detected 1 on the windshield. The wiper speed will vary based on the amount of moisture detected on the windshield and the sensitivity setting. The wipers will continue to wipe as long as moisture is detected. Keep the outside of the windshield clean, especially the area around the interior mirror where the sensor is located, or sensor performance may be affected. 2014 Expedition (exd) Owners Guide gf, 1st Printing, June 2013 USA (fus)