2014 Ford Expedition Owner Manual Printing 1 - Page 58

Keys and Remote Control 57 Note: Your vehicle's keys were issued with a security label that provides important vehicle key cut information. Keep the label in a safe place for future reference. Replacing the Battery Note: Refer to local regulations when disposing of transmitter batteries. Note: Do not wipe off any grease on the battery terminals or on the back surface of the circuit board. Note: Replacing the battery will not delete the transmitter from your vehicle. The transmitter should operate normally. The remote control uses one coin-type three-volt lithium battery CR2032 or equivalent. Integrated Keyhead Transmitter 1. Twist a thin coin in the slot near the key 1 ring to remove the battery cover (1). 2. Carefully peel up the rubber gasket (2) 2 from the transmitter if it does not come off with the battery cover. 3 3. Remove the old battery (3). 4. Insert the new battery. Refer to the instructions inside the integrated keyhead transmitter for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 5. Reinstall the rubber gasket. 6. Snap the battery cover back onto the key. 2014 Expedition (exd) Owners Guide gf, 1st Printing, June 2013 USA (fus)