2012 Jeep Grand Cherokee Owner Manual SRT - Page 242

240 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: Before You Begin Programming HomeLinkா Be sure that your vehicle is parked outside of the garage • Erasing all channels should only be performed when before you begin programming. programming HomeLink௡ for the first time. Do not erase channels when programming additional buttons. For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that • If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or, on the Internet at a new battery be placed in the hand-held transmitter of www.HomeLink.com for information or assistance. the device that is being programmed to the HomeLink௡ system. Programming A Rolling Code Erase all channels before you begin programming. To For programming garage door openers that were manuerase the channels place the ignition in the ON/RUN factured after 1995. These garage door openers can be position and press and hold the two outside HomeLink௡ identified by the "LEARN" or "TRAIN" button located buttons (I and III) for up 20 seconds or until the red where the hanging antenna is attached to the garage door opener. It is NOT the button that is normally used to indicator flashes. open and close the door. The name and color of the button may vary by manufacturer.