2012 Jeep Grand Cherokee Owner Manual SRT - Page 246

244 UNDERSTANDING THE FEATURES OF YOUR VEHICLE to pick up the signal during programming. Similar to this 4. Watch for the HomeLink௡ indicator to change flash Canadian law, some U.S. gate operators are designed to rates. When it changes, it is programmed. It may take up time-out in the same manner. to 30 seconds or longer in rare cases. The garage door may open and close while you are programming. It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage 5. Press and hold the programmed HomeLink௡ button door or gate motor. and observe the indicator light. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink௡ button you wish to program while keeping the HomeLink௡ indicator light in view. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink௡ button is pressed. • To program the two remaining HomeLink௡ buttons, 3. Continue to press and hold the HomeLink௡ button, repeat each step for each remaining button. DO while you press and release ("cycle"), your hand-held NOT erase the channels. transmitter every two seconds until HomeLink௡ has successfully accepted the frequency signal. The indicator If you unplugged the garage door opener/device for light will flash slowly and then rapidly when fully programming, plug it back in at this time. trained.