2010 Mazda RX-8 Owner's Manual - Page 106
2010 Mazda RX-8 Manual
Page 106 highlights
RX-8_8AT5-EA-09E_Edition1 Page106 Wednesday, April 15 2009 10:33 AM Black plate (106,1) Knowing Your Mazda Doors and Locks NOTE (POWER WINDOW RESET PROCEDURE) If the battery was disconnected during vehicle maintenance, or for other reasons such as a switch continues to be operated after the window is fully open/close, the power windows will not fully open and close automatically. Resetting of the automatic function can be performed using the driver's master control switch or the passenger door switch. The power window auto function reset procedure can be done on one or both door switches. The power window auto function will only resume on the side that has been reset. 1. Turn the ignition switch to the ON position. 2. Make sure that the power window lock switch located on the driver's door is not depressed. 3. Press the switch and fully open the power window. 4. Pull up the switch to fully close the power window and continue holding the switch for about 2 seconds after the window fully closes. 5. Repeat Steps 3-4 for the passenger power window. 6. Make sure that the power windows operate correctly using the door switches. Driver's window Passenger's window NOTE Pressing the power window switch once when the window is fully closed will only open it about 3 cm (1 in) to allow convenient ventilation of the cabin. Canceling the two-step down function To cancel the two-step down function for the power windows, carry out the following procedure using the master control switches. 1. Turn the ignition switch to the ON position and complete the following procedure within 5 seconds: Press the power window switch 2 times firmly, then pull it 2 times firmly. Owner master control switches 2. Turn the ignition switch to the LOCK position. 3. With the ignition switch in the LOCK position, and within 40 seconds, turn the ignition switch to the ON position and complete the following procedure within 5 seconds: Press the power window switch 2 times firmly, then pull 2 times firmly. Two-step down function With the power window completely closed, press the switch lightly and it will open and stop about 3 cm (1 in) from the top. If you continue to press and hold the switch, the window will resume opening all the way. 3-38 Form No.8AT5-EA-09E