2010 Mazda RX-8 Owner's Manual - Page 362

RX-8_8AT5-EA-09E_Edition1 Page362 Wednesday, April 15 2009 10:34 AM Black plate (362,1) Maintenance and Care Owner Maintenance Side-turn signal lights 1. Slide the light unit rearward. 2. Rotate the light unit clockwise as shown in the figure and pull it out. Brake lights/Taillights Due to the complexity and difficulty of the procedure, the LED bulbs should be replaced by an expert repairer, we recommend an Authorized Mazda Dealer. Rear turn signal lights, Reverse lights, Rear side marker lights 1. Pull the center section of the plastic retainer and remove the retainers and partially open the trunk side trim. Removal 3. Press the tab on the bulb socket and disconnect the connector cord. Installation 2. Turn the socket and bulb assembly counterclockwise and remove it. 3. Disconnect the bulb from the socket. Rear turn signal lights 4. Replace with a new light unit and install it in the reverse order of the removal procedure. NOTE The side-turn signal light bulb cannot be replaced. The entire light unit itself has to be replaced, therefore consult an Authorized Mazda Dealer for a replacement light unit. 8-32 Form No.8AT5-EA-09E