2010 Mazda RX-8 Owner's Manual - Page 375
2010 Mazda RX-8 Manual
Page 375 highlights
RX-8_8AT5-EA-09E_Edition1 Page375 Wednesday, April 15 2009 10:34 AM Black plate (375,1) Maintenance and Care Appearance Care Pay special attention to removing salt, dirt, mud, and other foreign material from the underside of the fenders, and make sure the drain holes in the lower edges of the doors and rocker panels are clean. Insects, tar, tree sap, bird droppings, industrial fallout, and similar deposits can damage the finish if not removed immediately. When prompt washing with plain water is ineffective, use a mild soap made for use on vehicles. Thoroughly rinse off all soap with lukewarm or cold water. Don't allow soap to dry on the finish. After washing the vehicle, dry it with a clean chamois to prevent water spots from forming. 2. Use a good grade of natural wax for metallic, mica, and solid colors. 3. When waxing, coat evenly with the sponge supplied or a soft cloth. 4. Wipe off the wax with a soft cloth. NOTE A spot remover to remove oil, tar, and similar materials will usually also take off the wax. Rewax these areas even if the rest of the vehicle doesn't need it. qRepairing Damage to the Finish Deep scratches or chips on the finish should be repaired promptly. Exposed metal quickly rusts and can lead to major repairs. WARNING Dry wet brakes by driving very slowly and applying the brakes lightly until brake performance is normal: Driving with wet brakes is dangerous. Increased stopping distance or the vehicle pulling to one side when braking could result in a serious accident. Light braking will indicate whether the brakes have been affected. Waxing Your vehicle needs to be waxed when water no longer beads on the finish. Always wash and dry the vehicle before waxing it. In addition to the vehicle body, wax the metal trim to maintain its luster. 1. Use wax which contains no abrasives. Waxes containing abrasive will remove paint and could damage bright metal parts. CAUTION If your Mazda is damaged and needs metal parts repaired or replaced, make sure the body shop applies anti-corrosion materials to all parts, both repaired and new. This will prevent them from rusting. qBright-Metal Maintenance l l l Use tar remover to remove road tar and insects. Never do this with a knife or similar tool. To prevent corrosion on bright-metal surfaces, apply wax or chrome preservative and rub it to a high luster. During cold weather or in coastal areas, cover bright-metal parts with a coating of wax or preservative heavier than usual. It would also help to coat them with noncorrosive petroleum jelly or some other protective compound. 8-45 Form No.8AT5-EA-09E