2010 Mazda RX-8 Owner's Manual - Page 361
2010 Mazda RX-8 Manual
Page 361 highlights
RX-8_8AT5-EA-09E_Edition1 Page361 Wednesday, April 15 2009 10:34 AM Black plate (361,1) Maintenance and Care Owner Maintenance 3. Remove the fog light unit by pulling it downward and then straight out using both hands. Front turn signal lights/Parking lights 1. Make sure the ignition switch is turned off and the headlight switch is off. 2. If you are changing the right bulb, start the engine, turn the steering wheel all the way to the right, and turn off engine. If you are changing the left bulb, turn the steering wheel to the left. 3. Turn the center section of the plastic retainer counterclockwise and remove the retainers and partially peel back the mudguard. Removal NOTE When pulling out the fog light unit, be careful not to allow the bulb socket to contact the oil cooler. 4. Press the tab on the bulb socket and disconnect the connector cord. 5. Rotate the bulb socket counterclockwise as shown in the figure and remove it. Installation 4. Turn the socket and bulb assembly counterclockwise and remove it. 5. Disconnect the bulb from the socket. 6. Replace the bulb. 7. Reinstall the bulb socket in the reverse order of the removal procedure. 6. Install the new bulb in the reverse order of the removal procedure. 8-31 Form No.8AT5-EA-09E