2010 Mazda RX-8 Owner's Manual - Page 254

RX-8_8AT5-EA-09E_Edition1 Page254 Wednesday, April 15 2009 10:33 AM Black plate (254,1) Interior Comfort Audio System NOTE Master code: The Master Code is used to initialize or reinitialize the ID code in the event that the code is not set to [0000] and/or the personalized ID code is not known. The initialization process resets the ID code to [0000]. The master code can potentially defeat the intent of the security of the parental lock if it is located by persons not authorized by the owner to access certain channels. SIRIUS Satellite Radio Master Code: [0913] 3. "SR1 - - - -" appears, which indicates that it is ready for code input. 4. Input the registered ID code using channel preset buttons 1-4. Example: When the registered ID code is "2323", input "2323". At this time "SR1 2323" is displayed. Press 1 for the first digit, 2 for the second, 3 for the third, and 4 for the last digit. For example, if your number is 2323, press 1 three times (includes 0), 2 four times, 3 three times, and 4 four times. If the display goes off while inputting, begin from Step 1. NOTE The registered ID code is the default [0000] at the time of factory shipment. If [0000] results in "Err" on the display, go to the "INITIALIZATION OF ID CODE" section to reset to [0000]. NOTE l l l When a numeric value other than the master code is input and the auto memory button is pressed, "SR1 Err" is displayed and then it returns to the "SR1 - - - -" display again. If an ID code is not input for ten seconds, "Err" is displayed and it returns to the former display. Channel preset buttons 1, 2, 3, 4 and the auto memory button are used for inputting the ID code. Buttons 5 and 6 cannot be used. (Verification with the registered ID code) 5. Determine the input code by pressing the auto memory button. 6. If it does not match with the previously registered code, "SR1 Err" is displayed and then it returns to "SR1 7. If it matches with the previously registered code, "ENTER PIN" appears again and it switches to code input mode. 8. "SR1 - - - -" appears, and it is ready for input of the new ID code. (New ID code input) 9. Input the new ID code using channel preset buttons 1-4. Example: If "1234" is input as the new code, "SR1 1234" is displayed. Change of ID code Setting condition: SAT mode When changing the ID code, the new ID code is input after the previous one is input first. (Registered ID code input) 1. Press and hold the auto memory button, then press channel preset button 5. Hold both buttons together for 1.5 seconds. 2. "ENTER PIN" appears for two seconds which indicates that it is in code input mode. 6-40 Form No.8AT5-EA-09E