2010 Mazda RX-8 Owner's Manual - Page 176

RX-8_8AT5-EA-09E_Edition1 Page176 Wednesday, April 15 2009 10:33 AM Black plate (176,1) Driving Your Mazda Starting and Driving NOTE Each tire pressure sensor has a unique ID signal code. The signal code must be registered with the TPMS before it can work. The easiest way to do it is to have an Authorized Mazda Dealer change your tire and complete ID signal code registration. Replacing tires and wheels CAUTION Ø When replacing/repairing the tires or wheels or both, have the work done by an Authorized Mazda Dealer, or the tire pressure sensors may be damaged. Ø The wheels equipped on your Mazda are specially designed for installation of the tire pressure sensors. Do not use non-genuine wheels, otherwise it may not be possible to install the tire pressure sensors. Be sure to have the tire pressure sensors installed whenever tires or wheels are replaced. When having a tire or wheel or both replaced, the following types of tire pressure sensor installations are possible. l The tire pressure sensor is removed from the old wheel and installed to the new one. l The same tire pressure sensor is used with the same wheel. Only the tire is replaced. l A new tire pressure sensor is installed to a new wheel. NOTE l When having tires changed at an Authorized Mazda Dealer Tire pressure sensor ID signal code registration is completed when an Authorized Mazda Dealer changes your vehicle's tires. When changing tires yourself If you or someone else changes tires, you or someone else can also undertake the steps for the TPMS to complete the ID signal code registration. 1. After tires have been changed, turn the ignition switch to the ON position, then turn it back to the ACC or LOCK position. 2. Wait for about 15 minutes. 3. After about 15 minutes, drive the vehicle at a speed of at least 25 km/h (16 mph) for 10 minutes and the tire pressure sensor ID signal code will be registered automatically. NOTE If the vehicle is driven within about 15 minutes of changing tires, the tire pressure monitoring system warning light will flash because the sensor ID signal code would not have been registered. If this happens, park the vehicle for about 15 minutes, after which the sensor ID signal code will register upon driving the vehicle for 10 minutes. l The tire pressure sensor ID signal code must be registered when a new tire pressure sensor is purchased. For purchase of a tire pressure sensor and registration of the tire pressure sensor ID signal code, consult an Authorized Mazda Dealer. When reinstalling a previously removed tire pressure sensor to a wheel, replace the grommet (seal between valve body/sensor and wheel) for the tire pressure sensor. 5-34 Form No.8AT5-EA-09E