2015 Nissan Murano Owner's Manual - Page 140
2015 Nissan Murano Manual
Page 140 highlights
matically stop transmitting. Continue to press and hold the desired HomeLink® button while you press and re-press ("cycle") your hand-held transmitter every 2 seconds until the frequency signal has been learned. The HomeLink® indicator light will flash slowly and then rapidly after several seconds upon successful training. DO NOT release until the HomeLink® indicator light flashes slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. The rapid flashing indicates successful training. Proceed with "Programming HomeLink®" step 3 to complete. If the device was unplugged during the programming procedure, remember to plug it back in when programming is completed. PROGRAMMING TROUBLEDIAGNOSIS If the HomeLink® does not quickly learn the hand-held transmitter information: ● replace the hand-held transmitter batteries with new batteries. ● position the hand-held transmitter with its battery area facing away from the HomeLink® surface. ● press and hold both the HomeLink® and hand-held transmitter buttons without interruption. ● position the hand-held transmitter 1 - 3 in (26 - 76 mm) away from the HomeLink® surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-355-3515. CLEARING THE PROGRAMMED INFORMATION The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed. For additional information, refer to "Reprogramming a single HomeLink® button" in this section. To clear all programming: 1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash in approximately 10 seconds. Do not hold for longer than 20 seconds. 2. Release both buttons. HomeLink® is now in the programming mode and can be programmed at any time beginning with "Programming HomeLink®" - Step 1. OPERATING THE HOMELINK® UNIVERSAL TRANSCEIVER The HomeLink® Universal Transceiver, after it is programmed, can be used to activate the programmed device. To operate, simply press and release the appropriate programmed HomeLink® Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted. For convenience, the hand-held transmitter of the device may also be used at any time. REPROGRAMMING A SINGLE HOMELINK® BUTTON To reprogram a HomeLink® Universal Transceiver button, complete the following: 1. Press and hold the desired HomeLink® button. DO NOT release the button. Instruments and controls 2-53