2015 Nissan Murano Owner's Manual - Page 162

REMOTE STARTING THE VEHICLE To use the remote start feature to start the engine perform the following: 1. Aim the Intelligent Key at the vehicle. 2. Press the doors. LOCK button to lock all Depress and hold the brake then press the pushbutton ignition switch to the ON position before driving. For additional information, refer to "Driving the vehicle" in the "Starting and driving" section of this manual. CANCELING A REMOTE START To cancel a remote start, perform one of the following: ● Aim the Intelligent Key at the vehicle and until the parking lights turn off. press ● Turn on the hazard warning flashers. ● Cycle the ignition switch ON and then OFF. ● The extended engine run time has expired. ● The first 10 minute timer has expired. ● The engine hood has been opened. ● The shift lever is moved out of park. ● The alarm sounds due to illegal entry into the vehicle. ● The ignition switch is pushed without an Intelligent Key in the vehicle. ● The ignition switch is pushed with an Intelligent Key in the vehicle but the brake pedal is not depressed. EXTENDING ENGINE RUN TIME The remote start feature can be extended one time by performing the steps listed in "Remote starting the vehicle" in this section. Run time will be calculated as follows: ● The first 10 minute run time will start when the remote start function is performed. ● The second 10 minutes will start immediately when the remote start function is performed again. For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes. ● Extending engine run time will bring you to the two remote start limit. A maximum of two remote starts, or a single start with an extension, are allowed between ignition cycles. The ignition switch must be cycled to the ON position and then back to the OFF position before the remote start procedure can be used again. 3. Within 5 seconds press and hold the remote start button until the turn signal lights flash and the tail lamps turn on. If the vehicle is not within view press and hold the remote start button for at least 2 seconds. The following events will occur when the engine starts: ● The parking lights will turn on and remain on as long as the engine is running. ● The doors will be locked and the climate control system may come on. ● The engine will continue to run for 10 minutes. Repeat the steps to extend the time for an additional ten minutes. For additional information, refer to "Extending engine run time" in this section. Pre-driving checks and adjustments 3-19