2015 Nissan Murano Owner's Manual - Page 221

APPS button Press the APPS button to launch the Smartphone Integration Mode. For additional information, refer to "NissanConnectSM with Mobile Apps" in this section regarding this feature. For additional information, refer to "Bluetooth® Hands-Free Phone system without Navigation" in this section regarding connecting your phone. XM band select Press the XM button to change the band as follows: XM1* → XM2* → XM3* → XM1 When the XM button is pressed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. The last station played will also come on when (power) control the VOL (volume)/ knob/button is pressed on. *When the XM button is pressed, the satellite radio reception will not be available unless an optional satellite receiver and antenna are installed and a SiriusXM® Satellite Radio service subscription is active. Satellite radio is not available in Alaska, Hawaii and Guam. If a compact disc is playing when the XM button is pressed, the compact disc will automatically be turned off and the last radio station played will come on. TUNE/SCROLL knob (Tuning) Turn the TUNE/SCROLL knob to the left or right for manual tuning. SEEK tuning or SEEK buttons to tune Press the from low to high or high to low frequencies and to stop at the next broadcasting station. SCAN tuning Press the SCAN button to stop at each broadcasting station for 5 seconds. SCAN will appear on the screen while the radio is scan tuning. Pressing the button again during this 5 second period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN button is not pressed within 5 seconds, SCAN tuning moves to the next station. 1 to 6 Station memory operations Six stations can be set for the AM band. Twelve stations can be set for the FM band (six for FM1, six for FM2). 1. Choose the radio band AM, FM1 or FM2 using the FM·AM select button. 2. Tune to the desired station using the TRACK button. SEEK button or the Press and hold any of the desired station memory buttons (1 - 6) until the preset number is updated on the display and the sound is briefly muted. FM/AM/SAT radio operation FM·AM button Press the FM·AM button to change the band as follows: AM → FM1 → FM2 → AM If another audio source is playing when the FM·AM button is pressed, the audio source playing will automatically be turned off and the last radio station played will begin playing. The FM stereo indicator (STEREO) is shown on the screen during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. 4-40 Display screen, heater, air conditioner, audio and phone systems