2015 Nissan Murano Owner's Manual - Page 178

this manual, and "Tilt/Telescopic Steering" and "Outside mirrors" in this section. 3. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2). 4. The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds. 5. The chime will sound if the memory has been stored. NOTE: If a NEW memory position is stored in the same memory switch, the previous memory position will be overwritten by the new stored position. Linking a key fob to a stored memory position Each key fob can be linked to a stored memory position (memory switch 1 or 2) with the following procedure. 1. Follow steps 1-3 listed in Memory Storage Function in this section for storing the memory position. 2. The indicator light for the pushed memory switch will come ON, while the indicator light is ON for 5 seconds, press the button on the key fob. The indicator light of the linked memory switch will blink. After the indicator light goes off, the key fob is linked to that memory setting. Once it is linked, when the ignition switch is placed in the OFF position, pressing the button on the key fob will move the driver's seat, steering wheel and outside mirrors to the linked memory switch position. NOTE: If a NEW memory positon is stored int he linked memory switch then the key fob will link to the NEW position and overwrites the previous position. The system contains a ON/OFF setting for when the settings are not to be memorized. Linking an Intelligent Key to the meter display (if so equipped) Each Intelligent Key, up to a maximum of four, can be linked to the meter display. 1. When the system is enabled, the recognized Intelligent Key is displayed at start up, as well as within "Key Link Settings". 2. When the system is active, the meter setting items are memorized for each Intelligent Key that has been enabled in the system. 3. The auto drive positioner system is memorized automatically when the ignition switch is turned from ON to OFF by the Intelligent Key with no need to set separate buttons for recalling and memorizing positions. 4. If two Intelligent Keys are in the vehicle, the system will recognize the Intelligent Key that was used most recently, such as to unlock/lock the door. Confirming memory storage Push the SET switch. ● If a memory position has not been stored in the switch (1 or 2) the indicator light for the respective switch will come ON for approximately 0.5 seconds. ● If a memory position has been stored in the switch (1 or 2) then the indicator light for the respective switch will stay on for approximately 5 seconds. Pre-driving checks and adjustments 3-35