2015 Nissan Murano Owner's Manual - Page 286

● When the shift lever is not in the D (Drive) or Manual mode ● When the parking brake is applied ● When the brakes are operated by the driver When the SET/COAST (-) switch is pushed under the following conditions, the system cannot be set. A warning chime will sound and a message will pop up. ● When the VDC system is off (To use the ICC system, turn on the VDC system. Push the CRUISE ON/OFF switch to turn off the ICC system and reset the ICC switch by pushing the CRUISE ON/OFF switch again.) For additional information about the VDC system, refer to "Vehicle Dynamic Control (VDC) system" in this section. ● When ABS or VDC (including the TCS) is operating ● When a wheel is slipping (To use the ICC system, make sure the wheels are no longer slipping. Push the CRUISE ON/OFF switch to turn off the ICC, and reset the ICC system by pushing the CRUISE ON/OFF switch again.) System operation WARNING Normally when controlling the distance to a vehicle ahead, this system automatically accelerates or decelerates your vehicle according to the speed of the vehicle ahead. Depress the accelerator to properly accelerate your vehicle when acceleration is required for a lane change. Depress the brake pedal when deceleration is required to maintain a safe distance to the vehicle ahead due to its sudden braking or if a vehicle cuts in. Always stay alert when using the ICC system. The driver sets the desired vehicle speed based on the road conditions. The ICC system displays the set speed. Vehicle detected ahead: When a vehicle is detected in the lane ahead, the ICC system decelerates the vehicle by controlling the throttle and applying the brakes to match the speed of a slower vehicle ahead. The system then controls the vehicle speed based on the speed of the vehicle ahead to maintain the driver selected distance. LSD2254 1 ᭺ 2 ᭺ System set display with vehicle ahead System set display without vehicle ahead Starting and driving 5-41