2015 Nissan Murano Owner's Manual - Page 54
2015 Nissan Murano Manual
Page 54 highlights
7. Check to make sure that the child restraint is properly secured prior to each use. If the seat belt is not locked, repeat steps 1 through 6. After the child restraint is removed and the seat belt fully retracted, the ALR mode (child restraint mode) is canceled. Follow these steps to install a forward-facing child restraint in the rear bench seats using the LATCH system: 1. Position the child restraint on the seat. Always follow the child restraint manufacturer's instructions. FORWARD-FACING CHILD RESTRAINT INSTALLATION USING LATCH LRS2397 Rear-facing - step 6 6. After attaching the child restraint, test it before you place the child in it. Push it from side to side while holding the child restraint near the seat belt path. The child restraint should not move more than 1 inch (25 mm), from side to side. Try to tug it forward and check to see if the belt holds the restraint in place. If the restraint is not secure, tighten the seat belt as necessary, or put the restraint in another seat and test it again. You may need to try a different child restraint. Not all child restraints fit in all types of vehicles. For additional information, refer to all Warnings and Cautions in the "Child Safety" and "Child Restraints" sections of this manual before installing a child restraint. Do not use the lower anchors if the combined weight of the child and the child restraint exceeds 65 lbs (29.5 kg). If the combined weight of the child and the child restraint is greater than 65 lbs (29.5 kg), use the vehicle's seat belt (not the lower anchors) to install the child restraint. Be sure to follow the child restraint manufacturer's instructions for installation. Safety-Seats, seat belts and supplemental restraint system 1-35