1998 Oldsmobile Aurora Owner's Manual - Page 125
1998 Oldsmobile Aurora Manual
Page 125 highlights
To program a garage door opener with therolling code feature, do the following: universal 1. Program your hand-held transmitter to the transmitter by following the steps provided under "Programming the Transmitter"earlier. button on the garage door opener 2. Locate the training receiver. The exact location color will vary and among brands. Refer to your garage door opener manufacturer's owner's manual to locate the training button. button on the garage door 3. Press the training opener receiver for one to two seconds. Erasing Channels To erase all three programmed channels, hold down the two outsidebuttons until the red light begins to flash. Individual channels cannot be erased, but be can reprogrammed using the procedure for programming the transmitter explainedearlier. Accessories Accessories foryour universal transmitter are available from the manufacturer of the unit. If you would like additional information please 1-800-355-35 15. call 4. Return to your vehicle and press the programmed button on the universal transmitter until the red light flashes rapidly (about two seconds). 5. Release thebutton, then press it again to confirm it was programmed to the garagedoor opener receiver. You may now use either the universal transmitter or the hand-held transmitter toopen your garage door. If you still have difficulty in programming and require assistance, please call your retailer. 2-59