1998 Oldsmobile Aurora Owner's Manual - Page 317
1998 Oldsmobile Aurora Manual
Page 317 highlights
A safety beltthat isn't properly routed through the seat cushion or is twisted won't provide the protection needed in a crash. If the safety belt hasn't been routed through the seat cushion at all, it won't be there to work for the next passenger. The person sitting in thatposition could be badlyinjured. After reinstalling the seat cushion, always check be sure that the to safety belts are properly routed and arenot twisted. 1. Buckle the center passenger position safety belt, and then route the safety belts through the proper slots in the seat cushion.Don't let the safety belt get twisted. of 2. Slide the rear the cushion up and underthe seatback so the rear locating guideshook into the wire loops onthe back frame. 3. With the seat cushion lowered,push rearward and then press down onthe seat cushion until the spring locks onboth ends engage. 4. Check to make sure the safety belts are properly routed and that no portion of any safety belt is trapped under the seat. Also make sure seat the cushion is secured. Rear Compartment Fuse Blocks Once the seat is removed, you'll find twofuse panels on the driver's sideof the battery. Each is protected by a plastic box with four tabs. Pull up on all four tabs at the same time to loosen them and pull off the box. Of these twopanels, the cover on the passenger's side fuse panel has an extra plastic cap attachment.You'll need to slide this out of the grooves which hold it there before removing the rest of the box. To replace the covers, line the four up and simply tabs snap them back into place. The extraplastic cap attachment slides back into place. 6-65