1993 Pontiac Bonneville Owner's Manual - Page 259
1993 Pontiac Bonneville Manual
Page 259 highlights
Service Appearance Care Cleaning the inside bur of Pontiac Use a vacuum cleaner often to get ridof dust and loose dirt. Wipe vinyl with a clean, damp cloth. Your Pontiac dealer has two GM cleaners-a solvent-type spot lifter and a foam-type powdered cleaner. They will clean normal spots and stains very well. Here are some cleaning tips: Always read the instructions on the cleaner label. Clean up stains as soon as you canbefore they set. Use a clean cloth or sponge, and change to a cleanarea often. A soft brush may be used if stains are stubborn. Use solvent-type cleanersin a wellventilated area only. If you use them, don't saturate the stained area. If a ring forms after spot cleaning, clean the entire area immediately or it will set. Using Foam-Type Cleaner on Fabric Vacuum and brush the area to remove any loose dirt. Always clean a whole trim panel or section. Mask surrounding trim along stitch or welt lines. Mix Multi-Purpose Powdered Cleaner following the directions on the container label. Use suds only and apply with a clean sponge. Don't saturate the material. Don't rub it roughly. As soon as you've cleaned the section, use a sponge to remove the suds. Rinse the section with a clean, wet sponge. Wipe off what's left with a slightly damp papertowel or cloth. Then dry it immediately with an air hose, a hair dryeror a heat lamp. Wipe with a clean cloth.