1999 Subaru Legacy Owner's Manual - Page 48
1999 Subaru Legacy Manual
Page 48 highlights
Doors and locks J Passive arming When passive arming mode has been programmed by the dealer, arming of the system is automatically accomplished without using the remote transmitter. Note that in this mode, DOORS MUST BE MANUALLY LOCKED. B To enter the passive mode WARNING Do not disconnect or tamper with any yellow connector and/or any harness covered with yellow insulation and/or tape. Doing so could result in accidental inflation of the SRS AIRBAG or could make the SRS AIRBAG system inoperative, which may result in serious injury. White (1 p) Connector for SRS AIRBAG System (yellow) HB1006BA HB1007CB 1. Remove the side sill cover on the driver's side. 1) Open the driver's door. 2) Remove the clip by prying the edge with screwdriver. 3) Remove the side sill cover by pulling it up. 2. Connect the white (1 pole) connector. 3. Install the side sill cover. To place the system in active arming mode (remote required for activation), disconnect the white connector. - CONTINUED - 1-21