2008 Subaru Outback Owner's Manual - Page 134

Instruments and controls 3-15 & Clock (Vehicle with Navigation System) & SI-DRIVE display needles . Present date & time . Birthday . Anniversary Within 12 seconds after turning on the ignition switch, press the " /SET" switch for at least 2 seconds. The display can be switched as shown below by pressing the " " or " " switch. The clock receives the correct time from the navigation system. To adjust the time shown by the clock, refer to the separate "Operating Instructions for Monitor System" and adjust the time of the navigation system. 1) 2) 3) 4) *: Sport Sharp (S#) mode Sport (S) mode Intelligent (I) mode Throttle angle This display means that the Sport Sharp (S#) mode is in the selected condition. CAUTION To ensure safety, do not attempt to set the time during driving, as an accident could result. This display indicates the current SIDRIVE mode with its throttle angle. For details of SI-DRIVE mode, refer to the "SI-DRIVE (Except 2.5-liter non-Turbo models)" section in chapter 7. *: "Present date & time", "Birthday" and "Anniversary" can be registered in the "Date/Time" setting menu. Refer to the following procedure for further steps. ! Initial movement setting It is possible to activate or deactivate the initial movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the "ON" position. - CONTINUED - & Meter settings The following items can be set or registered on the multi-information display as desired. . Initial movements of the meter/gauge