3Com 3CRWE554G72T User Guide - Page 71
Address, using DHCP., Initial IP Address, Initial Subnet Mask
UPC - 662705481685
View all 3Com 3CRWE554G72T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Internet Settings 71 To setup the Router for use with a PPTP connection, use the following procedure: 1 Select PPTP (used by some European providers) in the IP Allocation Mode field. (Figure 50) 2 Enter your PPTP server address in the PPTP Server Address text box (this is typically the address of your modem). 3 Enter your PPTP user name in the PPTP User Name text box. 4 Enter your password in the PPTP Password text box. 5 Enter your Primary DNS Address and Secondary DNS address. Your ISP may provide you with primary and secondary DNS addresses. If they have been provided, enter the addresses in the appropriate text boxes. If not, leave 0.0.0.0 in the boxes. 6 Enter the MTU value supplied by your ISP. If you do not know this, leave it at the default value. The default is 1460. 7 Select an idle time from the Maximum Idle Time drop-down list. This value will correspond to the amount of idle time (no Internet activity) that will pass before the Router automatically ends your PPTP session. 8 IP settings must be used when establishing a PPTP connection. To obtain an IP address, either: ■ Check the Get IP By DHCP check box, if you want to obtain an IP address from a DHCP Server on the network. With this check box enabled, you can click Release to release the WAN IP Address for the Router, or click Renew to renew the current WAN IP Address, using DHCP. ■ Fill in the Initial IP Address, Initial Subnet Mask and Initial Gateway fields if your ISP has provided you with these settings. Alternatively, if the PPTP server is located in your DSL modem, click Suggest to select an IP address on the same subnet as the PPTP server. Check all of your settings, and then click Apply.