Airlink AML001 Manual - Page 44
B<value>, When Modem Is On-Line Command State During Data Connection, K0, \K1, K2, \K3, K4, \K5
View all Airlink AML001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Appendix A AT Commands \K3 Sends a break to the remote modem immediately. \K5 Sends a nondestructive, non expedited break to the remote modem (default). The second case occurs when the modem is in the on-line command state (waiting for AT commands) during a data connection, and the \B command is received in order to send a break to the remote modem. When Modem Is On-Line Command State During Data Connection: \K0, \K1 Clears data buffers and sends a break to the remote modem. \K2, \K3 Sends a break to the remote modem immediately. \K4, \K5 Sends a break to the remote modem in sequence with data (default). Finally, the third case occurs when a break is received from a remote modem during a connection. When Break Is Received During Connection: \K0, \K1 Clears data buffers and sends a break to the DTE. \K2, \K3 Sends a break to the DTE immediately. \K4, \K5 Sends a break to the DTE in sequence with received data (default). \N-Select Error Control Mode Use this command to select the type of error control used by the modem when sending or receiving data. \N0 Buffer mode. No error control (same as &Q6). \N1 Direct mode. \N2 MNP or disconnect mode. The modem attempts to connect using MNP 2-4 error control procedures. If this fails, the modem disconnects. This is also known as MNP reliable mode. \N3 V.42, MNP, or buffered (default). The modem attempts to connect in V.42 error control mode. If this fails, it will attempt to connect in MNP mode. If this also fails, soft modem connects in buffer mode and continues operation. This is also known as V.42/ MNP auto reliable mode (same as &Q5). \N4 V.42 or disconnect. The modem attempts to connect in V.42 error control mode. If this fails, the modem disconnects. \N5 V. 4 2 , MNP, or buffered (same as \N3). \N7 V. 4 2 , MNP, or buffered (same as \N3). \Q-Local Flow Control Selection Use this command to set the local flow control method. 43