Airlink AML001 Manual - Page 65

PCI Modem Card User's Manual +FTS= causes the modem to terminate a transmission and wait for x 10 ms before responding with the OK result code. For example, = 5 results in a 50 ms interval. has a range of 0-255. A.2 Result Codes The soft modem AT command handler responds to commands from the caller and to activity on the line via result codes. Table below presents a summary of these result codes. Two forms of each result code are available. The long-form, or verbose, response is given when V1 is selected, and the short-form, numeric response is given when V0 is selected. The long-form code is preceded and terminated by the sequence . The short-form is also terminated by , but it has no preceding sequence. If result codes are suppressed, nothing is returned to the caller. Result Code OK CONNECT RING NO CARRIER Numeric Code 0 1 2 3 ERROR 4 CONNECT 1200 EC* 5 NO DIALTONE 6 BUSY 7 NO ANSWER 8 CONNECT 2400 EC* 10 CONNECT 4800 EC* 11 CONNECT 9600 EC* 12 CONNECT 14400 EC* 13 CONNECT 19200 EC* 14 CONNECT 7200 EC* 24 CONNECT 12000 EC* 25 CONNECT 16800 EC* 86 CONNECT 300 EC* 40 CONNECT 21600 EC* 55 CONNECT 24000 EC* 56 Description Acknowledges the execution of a command line. Modem connected to line. Incoming ring signal has been detected. Modem lost carrier signal, does not detect carrier signal, or does not detect answer tone. Invalid command. Connection at 1200 bits/s. No dial tone detected. Busy signal detected. Remote end never answered. Connection at 2400 bits/s. Connection at 4800 bits/s. Connection at 9600 bits/s. Connection at 14400 bits/s. Connection at 19200 bits/s. Connection at 7200 bits/s. Connection at 12000 bits/s. Connection at 16800bits/s. Connection at 300 bits/s. Connection at 21600 bits/s. Connection at 24000 bits/s. 64