Alpine IVE-W530 Owner's Manual (english) - Page 28
Switching Display Modes, Switching the Visual Source Only (Simultaneous Function) - screen goes black
View all Alpine IVE-W530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
2 Touch [Rear]. Rear Select display appears. • This function cannot be used when "Setting the Picture/Sound Output" (page 38) is set to OFF in the System Setup. • If [Main] on the Rear Select screen is touched, the screen changes to the main source screen. 3 Touch the desired source such as visual (auxiliary input, built-in DVD, etc.) to select. • Touch [Off] to cancel the rear entertainment function. • When the AUX1 IN is set to OFF and AUX2 IN is set to iPod Video, the AUX source is not displayed. Refer to "Setting the AUX Mode" (page 37). • Some sources such as DTV (TUE-T250DV), etc., can be displayed on the rear monitor only when they are the same as the main source. Switching Display Modes After carrying out the steps 1 to 3 of "To display the DVD mode screen" explained on page 29, perform the operation described below. While your vehicle is parked, touch [WIDE] on the visual source screen. Each touch changes the display modes as follows: Mode 1 Mode 2 Mode 3 Mode 1 (WIDE) (CINEMA) (NORMAL) (WIDE) Switching the Visual Source Only (Simultaneous Function) You can watch the video portion of another source while listening to the current source. 1 Touch [V.Sel]. The VISUAL selection screen appears. 2 Touch desired visual source. The visual source is switched to the selected one. Cancelling the Simultaneous Function 1 Touch [V.Sel]. 2 Touch [Normal]. The simultaneous function is canceled. • To apply the setting, set to V.Sel in "Setting the VISUAL Button" (page 32). • The simultaneous function cannot be used when the Audio source is in the navigation mode. When Navi is set in "Setting the VISUAL Button" (page 32), only the navigation screen can be recalled. • When the AUX1 IN is set to OFF and AUX2 IN is set to iPod Video, the AUX source is not displayed. Refer to "Setting the AUX Mode" (page 37). In Mode 1 (Wide), the monitor displays a normal picture wider to fit in a wide-screen monitor by evenly stretching out the picture horizontally. In Mode 2 (Cinema), the monitor displays a normal picture by stretching out the picture horizontally and vertically. This mode is good for displaying a cinema type picture at the 16:9 ratio. Blackout Mode On and Off When Blackout mode is turned on, the monitor display will turn off to reduce power consumption. This additional power enhances the sound quality. 1 Touch [V.Sel]. The VISUAL selection screen is displayed. 2 Touch [Off]. The backlit-display portion goes out. 3 Touch [Off] again to cancel the display backlight. • To apply the setting, set to V.Sel in "Setting the VISUAL Button" (page 32). • If any button on the unit is pressed or main screen is touched during Blackout mode, the function will be displayed for 5 seconds. This confirms the operation as well as allowing for additional functions before returning to Blackout mode. In Mode 3 (Normal), the monitor displays a normal picture at the center of the screen with a vertical black band at each side. 28-EN