Brother International BAS-342E Instruction Manual - English - Page 27
Using, switch, Checking, sewing, pattern
View all Brother International BAS-342E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
6. Panel operation 6-4. Using the TEST switch (Checking the sewing pattern) Use the TEST switch to begin sewing again from any desired point when the thread breaks or the bobbin thread runs out. 1. Press the TEST switch 65. The test indicator e will light. -7-7. • TEST 7\ 5-,yiivi), STEP BACK 2. If the work clamp is raised, depress the work clamp lifter pedal 0 to lower the work clamp. 3. Press the starting pedal 0. NOTE After the feed mechanism has returned to the home position, it will then move the sewing start position and the program number will stop flash- ing. This only occurs the first time that a program is selected. 4. Press the starting pedal 0. (The needle will remain stationary as the work clamp advances through the pattern at low speed one stitch at a time. Press the presser lifter pedal 0 to fast forward. e • If the STEP BACK switch is pressed while moving at low speed, the work clamp will move in the forward direction in steps of 100 stitches. 5. When the work clamp reaches the desired position, press the TEST switch (1). The work clamp will stop, and the test indicator m will go out. If the work clamp was stopped too early, press theTEST switch e again to proceed. • If the work clamp was stopped too late, press the STEP e BACK switch to advance the work clamp one stitch at a time. Resuming operation from a stopping point 6. Sewing will start when the starting pedal 0 is pressed. BAS-341E • 342E 20