Brother International BAS-342E Instruction Manual - English - Page 28

6. Panel operation 6-5. Using the emergency stop switch Press the emergency stop switch to immediately stop the sewing machine during actual sewing or when in the test mode. 0 0 as" 0 0 Clearing the error 1. Turn the EMERGENCY STOP switch 0 clockwise and then pull it forward to release it. 2. Press the STEP BACK switch 0 on the operation panel. (The buzzer will stop sounding.) 3. If you do not wish to resume sewing, press the EMER- GENCY STOP switch 0 once more to release it, and then press the STEP BACK switch 0 so that the operation panel display flashes. The sewing machine will STEP BACK then be ready for the next sewing operation. Releasing the EMERGENCY STOP switch using the STEP BACK switch is only possible when memory switch 0d is ON. If memory switch 0d is OFF, press the EMERGENCY STOP switch once more to release it. If memory switch No. 0d is OFF, press the EMERGENCY STOP switch 0 once more to release it. 5-7. I` TEST 7\5-y7A-) STEP BACK Foot switch Continuing sewing from a stopping point If you press the EMERGENCY STOP switch after the thread breaks or the bobbin thread runs out during sewing, you can then resume swing from the point where the thread broke or ran out. 1. Pres the EMERGENCY STOP switch to release it. 2. Press the STEP BACK switch m to trim the thread. 3. Press the STEP BACK switch 0) once more. (The sewing machine will move stitch by stitch in the reverse direction while this switch is pressed.) If the sewing machine moves back too far, press the TEST switch to move it forward again. Press the TEST switch again to stop the machine. 4. After you have reached the desired position, depress the foot switch to start sewing. BAS-341E • 342E 21