Brother International BAS-342E Instruction Manual - English - Page 46
Adjusting, needle, position
View all Brother International BAS-342E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
9. Standard adjutsments 9-11. Adjusting the needle up stop position 0 0 • The needle up stop position has been adjusted so that the tip of the needle stops 17.5 -19.5 mm above the top of the needle plate. • If adjustment is necessary, loosen the screw Oat the "U" mark of the machine pulley 0 and adjust the position of the machine pulley 0. The machine pulley.0 stops later if it is turned clockwise, and it stops earlier if it is turned counterclockwise. NOTE • The screw 0 is used by the needle down detection function and should not be loosened. • The screw 0 is a screw for detecting the machine stop position, and should not be loosened. • If the index mark is not inside the mark when be displayed (when memory switch No.14 is on).Turn the machine pulley to move the index mark to the correct position and then start the sewing machine. BAS-341E • 342E 39