Brother International BAS-342E Instruction Manual - English - Page 44
Changing, presser
View all Brother International BAS-342E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
9-8. Changing the presser foot lift • Standard presser foot 0 lift is 3 mm (max. 8 mm). 9. Standard adjutsments 3 - 5 mm ilncrease , I I //'/ I Decrease 0.5 - 1 mm Adjusting presser foot lift to 3 - 5mm 1. Loosen the stud screw 0 and open the intermittent cover 0. 2. Loosen the nut 0 and adjust the intermittent presser connecting rod 0 pisition. (When the intermittent presser connecting rod is raised, the lift will increase. When lowered, the lift will Adjusting presser foot lift to 5 - 8 mm 1. Turn the upper shaft to set the presser foot to its lowest point. Loosen the screw 0 of intermittent presser arm (R) 0. Adjust the clearance between the presser lifter 0 and the presser bar bush 0 to 0.5 - 1 mm. 2. Loosen the nut r and adjust the intermittent presser connecting rod 0 position. (When the intermittent presser connecting rod is raised, the lift will increase. When lowered, the lift will 3. Loosen the presser foot screw and adjust the height of the presser foot so that it is 0.5 mm above the top of the material being sewn when the presser foot is lowered. ore° caro IS O O If vertical movement of the presser foot is not required a). 1. Remove the face plate 2. Remove the stud screw Wand re-attach the intermitte connecting rode to the upper screw hole m of the intermit- tent presser arm R BAS-341E • 342E 37