Brother International BAS-342E Instruction Manual - English - Page 55

11. Changing special functions using the memory switches II Memory Switches (10 - 1F) SW No. memo-10 memo-11 When ON Milling device can be used (available as an option) Bobbin thread counter and production counter are adjusted when thread is trimmed memo 12 Work clamp is lowered by pressing work clamp first stage switch twice, without using work clamp second stage switch. When DIP switch ®-2 is ON, work clamp lowers in the order right left; when OFF, work clamp lowers in the order left right. Order is opposite when rising. memo-13 When work clamp is lowered, the starting switch causes locking; if the switch is released before locking, the work clamp rises When DIP switch ®-2 is ON, work clamp lowers in the order right-' left; when OFF, work clamp lowers in the order left-+right. Order is opposite when rising memo-14 memo-15 memo-16 memo-17 memo-18 Needle up error detected. ON when machine is equipped with signal tower indicator. (This indicator is available by special order.) ON when machine is equipped with thread nipper. (Thread nipper is available by special order.) ON when machine is equipped with reset switch. (Reset switch is available by special order.) Starting switch causes work clamp to drop in order right- left-÷forward control is in the same order as starting, and for backward control the work clamp rises in the order left-qight using work clamp first stage switch (when DIP switch ®-2 is ON). When OFF, the left and right orders are reversed. memo 19 memo-1A Produces three work clamp signal outputs (right and left work clamp, and intermittent work clamp) so that a two-position air valve can be used. (Two-position air valve is available by special order.) When using a triple pedal (DIP switch 4-7 is also ON), the right is used exclusively to detect the home position. If DIP switch ®-7 is OFF, the left pedal causes left and right work clamps to be raised and lowered simultaneously. If ON, the left pedal causes the left work clamp to be raised and lowered, and the right work clamp lowers when starting pedal to sew memo-1b B430E single foot pedal can be used. DIP switch ®-7 is ON. memo-1c Bobbin thread counter is decremented at the start of sewing. memo-1d When using an air pressure drop detection switch. (This detection switch is available by special order.) memo-1E memo-1F Split number is changed automatically Program number is changed automatically IN Memory Switches (20 -' 2F) SW No. memo 20 memo-21 memo-22 When ON During feed test operation, feeding 100 stitches at a time is possible using the STEP BACK switch. After the home position is detected and the machine moves to the sewing start position, the work clamp rises automatically. When extended option output No. 1 is ON, the sewing machine starts automatically. memo-23 Set to ON when the bobbin changer is being used. (This part is available by special order.) memo-24--memo-2F BAS-341E • 342E 48