Brother International PR-1000 Operation Manual - Page 142
Setting the Machine to Stop at Color Changes
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
EMBROIDERING SETTINGS Setting the Machine to Stop at Color Changes The machine can be stopped at any time; however, if the machine is stopped while it is embroidering, it is better to go back a few stitches before continuing sewing to overlap the stitching. If the machine stops at a color change, it is not necessary to go back through the stitching before continuing embroidering. Stopping the machine at the next color change The machine can be set to stop before sewing the next color. While sewing the color before the point 1 where you wish to stop the machine, touch so that it changes to . Specifying pause locations before embroidering Pause locations can be specified in the change thread color screen, displayed by touching . Touch 1 in the pattern editing screen. After finishing sewing the area for the 2 current color, the next needle bar moves into position and the machine stops before sewing the next color. X changes back to . • If the machine is temporarily turned off, you will be asked if you wish to continue sewing or select a new pattern when the machine is turned on again. Touch to continue embroidering. (Refer to "Resume Embroidering After Turning Off the Machine" on page 120.) X The change thread color screen appears. Touch and so that the color at 2 the top of the thread color sequence display is the color where you wish to stop the machine before sewing it. 140