Brother International PR-1000 Operation Manual - Page 32
Preparing the thread guide, assembly
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
GETTING READY Adjust the orientation of the operation 3 panel. Loosen the thumb screw, adjust the operation panel to an easy-to-view orientation, and then tighten the thumb screw. Preparing the thread guide assembly Raise the thread guide assembly. CAUTION ● When setting up the thread guide assembly, set it up with the needle bar 6 position selected, otherwise the machine may malfunction. (Refer to "Moving and threading a selected needle bar" on page 62 for moving the needle bar.) 1 Thumb screw Adjust the angle of the operation panel. 4 Loosen the 2 thumb screws behind the operation panel, adjust the operation panel to an easy-to-view angle, and then tighten the thumb screws. Loosen the two thumb screws on top of the 1 thread guide assembly support. (Side view) 1 Thumb screws (Top view) Note ● Using the disc-shaped screwdriver included, loosen and firmly tighten the five thumb screws. 1 Turn the screw counterclockwise three or four times to loosen it. 30