Brother International PR-1000 Operation Manual - Page 254
up, and then lower it so that the screw fits
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 254 highlights
APPENDIX Pull the table toward you until the pins on 3 the mounting brackets (attached on each side to the bottom of the table) fit into the notches in the guide plates. While looking below the table, lightly lift it 5 up, and then lower it so that the screw fits into the notch at the front of the guide plate. 1 Pin 2 Notch Slide in the table while supporting it so that 4 it remains level. Push the table in until it lightly touches the machine. • If the table does not move smoothly, slightly lift it up, and then slide it in. 1 Notch at front Tighten the two thumb screws so that the 6 table is secured. 1 Thumb screw 252
APPENDIX
————————————————————————————————————————————————————————————————————————————
252
3
Pull the table toward you until the pins on
the mounting brackets (attached on each
side to the bottom of the table) fit into the
notches in the guide plates.
1
Pin
2
Notch
4
Slide in the table while supporting it so that
it remains level. Push the table in until it
lightly touches the machine.
• If the table does not move smoothly,
slightly lift it up, and then slide it in.
5
While looking below the table, lightly lift it
up, and then lower it so that the screw fits
into the notch at the front of the guide plate.
1
Notch at front
6
Tighten the two thumb screws so that the
table is secured.
1
Thumb screw