Brother International PR-1000 Operation Manual - Page 228
Deleting short stitches
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
BASIC SETTINGS AND HELP FEATURE ■ When using Tajima embroidery data (.dst) If "ON" is selected, touch and to 2 select the number of feed codes. The desired setting is displayed. Deleting short stitches If embroidery data other than our original patterns are used, the stitch length may be too short, possibly resulting in the thread or the needle breaking. In order to prevent this problem from occurring, the machine can be set to delete stitches with a short stitch length. Stitches with a length less than that specified in this function, can be deleted. When the embroidery machine is purchased, "0.3" was selected (delete stitches with a length of 0.3 mm or less). • A value between 1 and 8 can be specified. For example, if 3 is specified, sequential 3 jump codes will be converted to the trim code. But sequential 2 jump codes will not be converted to the trim code, it will be sewed as the feed (jump) stitch. Touch and 1 length. to select the stitch The desired size is displayed. Note ● You need to set the jump number same as the number that was used when the particular Tajima data was created. If the jump number is not matched, either unexpected trim or no trimming at trim expected point will happen. • A value between 0 and 1 millimeters if the units of measurements is set to "mm" (or a value between 0 and 0.04 inch if the units of measurements is set to "inch") can be specified. Note ● If the setting is changed from the previous setting, the new setting is only applied to the next embroidery. 226