Brother International PR-1000 Operation Manual - Page 266
Make sure that each hexagonal screw is, firmly tightened. If any screw remains, loosen, injuries may
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 266 highlights
APPENDIX Lightly press down the ring, and then use the 6 Allen screwdriver (large) to tighten the four hexagonal screws on the inside of the ring. Firmly tighten the screws. ■ Preparing the mounting jig Attach the mounting jig to a stable surface, such as a desk. Loosen the thumb screw for the mounting jig 1 to open the mounting bracket so that it is wider than the thickness of the mounting surface. 1 Ring CAUTION ● Make sure that each hexagonal screw is firmly tightened. If any screw remains loosen, injuries may result. Remove the pad inserted in step 5. 7 • The mounting bracket can be mounted onto a mounting surface with a thickness from 9 mm (3/8 inch) to 38 mm (1-1/2 inches). Securely clamp the mounting bracket onto 2 the mounting surface by tightening the thumb screw. ■ Installing the needle plate spacer Attach the needle plate spacer to the needle plate. 1 Mounting bracket 2 Mounting surface 3 Tighten thumb screw 1 Needle plate spacer 264