Brother International PR-1000 Operation Manual - Page 41
Installing the bobbin case
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Insert the bobbin into the bobbin case. 1 Installing the bobbin case Insert the bobbin case into the hook. 1 Insert the bobbin case while aligning the tab on the bobbin case with the notch in the hook, as shown in the illustration. 2 Note ● Check that the thread winds off the bobbin clockwise as shown in the illustration. If the bobbin is installed with the thread winding off in the opposite direction, the embroidery will not be sewn correctly. Pass the thread through the thread slit and 2 under the tension-adjusting spring. 1 Tab 2 Notch Fully insert the bobbin case until it snaps 2 into place. 1 Thread slit 2 Tension-adjusting spring Pull the thread about 50 mm (2 inches) 3 through the opening in the tension-adjusting spring. Close the hook cover. 3 1 About 50 mm (2 inches). Installing the Bobbin 39