Brother International PR-1000 Operation Manual - Page 30
Setting up the machine
View all Brother International PR-1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
GETTING READY Setting up the machine When setting up the machine, adjust the legs so that the machine is steady. Make sure that all packing tape affixed to the 1 machine is peeled off and that all packing material is removed. Set up the machine while making sure that 2 there is sufficient space around it. Minimum of 50 mm (2 inches) Use the included wrench to turn the 4 adjustable foot nut on the foot. Turning the nut in direction 1 lengthens the leg; turning the nut in direction 2 shortens the leg. 589 mm (23-3/16 inches) More than 210 mm (8-1/64 inches) 560 mm (22-13/32 inches) 220 mm (8-21/32 inches) More than 350 mm (13-7/8 inches) Adjust the legs so that the machine is steady. 3 Use the included wrench to loosen the lock nut on the leg that you wish to adjust. 1 Adjustable foot nut • Adjust all four legs so that they securely contact the desk or table, and the machine is level. After adjusting the legs to the desired length, 5 use the included wrench to tighten the nuts. 1 Lock nut 2 Adjustable foot nut X The foot can be turned. 1 Lock nut Press down on each corner of the 6 embroidery machine to check that it is stable. If it is still unstable, perform steps 3 through 5 again to adjust the legs. 28