Brother International PT-3600 Users Manual - English and Spanish - Page 52
Attaching the identification label - brothers
UPC - 012502602804
View all Brother International PT-3600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Getting Started Ch. 2 Getting Started Glossy side Tape end Slit 6 Hold the end of the stamp film in place with your thumb, and then pass the stamp film through the guides while pulling it tight. Fold over 7 Fold the other end of the stamp film over the other side of the stamp holder and hold it in place with your finger. Guides 9 Insert the stamp holder straight into the cap. NOTE ☞ Be sure that the cap correctly covers the stamp in order to prevent ink spills. ☞ When the stamp is not being used, firmly cover it with the cap and always store it standing up with the stamp facing downward. Do not leave the stamp laying on its side or leaning. ☞ Store stamp film holders and stamp film cassettes in a location where they are not exposed to high temperatures, high humidity or direct sunlight. Attaching the identification label 1 Insert a TZ tape cassette into the tape compartment. NOTE Use 1/2" (12-mm)-wide tape to make an identification label for an M-size stamp and use 3/4" (18mm)-wide tape to make a label for an L-size stamp. 8 Fit the frame over the stamp film, and then push the frame down into place. 2 Press p to print out the identification label. 3 After the label is cut off, affix it to the end of the holder so that its bottom edge is on the same side of the stamp holder as the raised "brother" logo. 40