Brother International PT-3600 Users Manual - English and Spanish - Page 76

Ch. 3 Functions R1 2 3 4 5 6 7 8 9 A B C RRRG H RI RJ 11/13 NLMO B. MARGIN AUTO AUTO 1.10 HELSINKI D E A F K QQQQQQQQQQQQ AUTO Length Margin Font Width Size 3 Press m or g until the desired setting is displayed, or use the number keys to type in the desired block margin width. NOTE ☞ To return the function to its default setting (AUTO), press the space bar. ☞ To change the setting in 0.1" (1.0 cm) steps, hold down either m or g, and then release the key when the desired setting is displayed. ☞ The block margins are displayed in the currently selected unit of measurement (inches or centimeters). The unit of measurement can be changed with the Setup functions. (Refer to page 80.) ☞ To return to the text without changing the for- matting, press e (OR hold down d and press 1). 4 Press n to apply the setting. NOTE To apply several format settings at the same time, continue pressing j or k to select the function, then pressing m or g to select the desired setting. Press n only after the necessary functions have been set. To change the setting for the Block Length function: 1 Hold down d and press 1 or 2. NOTE This step may be skipped if settings for several format functions are being applied at the same time. 2 Press j or k until B. LENGTH is displayed. The current setting is shown on the left side of the display. R1 2 3 4 5 6 7 8 9 A B C RRRG H RI RJ 12/13 NLMO B. LENGTH AUTO AUTO 1.10 HELSINKI D E A F K QQQQQQQQQQQQ AUTO Length Margin Font Width Size 3 Press m or g until the desired setting is displayed, or use the number keys to type in the desired block length. NOTE ☞ To return the function to its default setting (AUTO), press the space bar. ☞ To change the setting in 0.1" (1.0 cm) steps, hold down either m or g, and then release the key when the desired setting is displayed. ☞ The block length is displayed in the currently selected unit of measurement (inches or centimeters). The unit of measurement can be changed with the Setup functions. (Refer to page 80.) ☞ To return to the text without changing the for- matting, press e (OR hold down d and press 1 or 2). Block Length function (B. LENGTH) Normally, the length of each text block automatically adjusts to fit the length of the entered text. However, with the Block Length function, you can set each text block to a length between 0.25" and 38.84" (0.6 cm and 99.5 cm). 4 Press n to apply the setting. NOTE To apply several format settings at the same time, continue pressing j or k to select the function, then pressing m or g to select the desired setting. Press n only after the necessary functions have been set. Functions 64